1 Before Using the Machine
28
Before Using the Machine
1
5 Press the <TEST> button lightly with a sharp
edge such as a pen tip. The depressed <RESET>
button will stick out again.
If the <RESET> button sticks out, the ground
fault interrupter is properly working. If the
<RESET> button remains in the depressed
position, the ground fault interrupter has a
problem.
6 Press the <RESET> button back to the
depressed position.
<RESET> button
<TEST> button
If the circuit does not work properly, contact your local Fuji Xerox representative.
Do not attempt to remove a paper jammed deeply inside the product, particularly
a paper wrapped around a fusing unit or a heat roller. Otherwise, it may cause
injuries or burns. Switch off the power and then the main power inside the body
front cover immediately and contact your local Fuji Xerox representative.
Never touch the paper output area of the finisher during operation. It may cause
injuries.
Be careful in removing jammed staples.
Waste staples may come out with output paper. Be careful not to get injured by the
staples.
Never touch safety interlocks. When a front cover is open, safety interlocks become
activated to stop the machinery. Do not apply pressure on safety interlocks with a
coin or screwdriver. Otherwise, the machinery may become activated and cause
injuries.
Do not staple punched holes of paper. Sharp points of a staple may cause injuries.
Do not apply excessive force to hold thick document on the document glass. It may
break the glass and cause injuries.
To move this product to another location, contact Fuji Xerox Customer Support
Center.
Ventilate well during extended operation or mass copying. It may affect the office
air environment due to odor such as ozone in a poorly ventilated room.
Provide proper ventilation to ensure the comfortable and safe environment.
To Next Page
Loading...
Need help?
General
