Fuji Xerox docucentre-iv C4470

5 Tools
178
Tools
5
Port Number
Enter a port number for the Internet Services from 1 to 65535.
The default value is 80.
Important • Do not use the numbers assigned to the other ports.
Note • You cannot select [Port Number], if HTTP port is disabled.
To configure [Port Number], enable port status and reboot the machine, and then configure
[Port Number].
SOAP
Port Status
Select [Enabled] when you use an application program such as EasyOperator.
Port Number
Enter a port number for SOAP from 1 to 65535.
The default value is 80.
Important • Do not use the numbers assigned to the other ports.
WebDAV
Port Status
Select [Enabled] when you use an application program such as EasyOperator and Network
Scanner Utility3 to access folders in the machine.
Note • You cannot select [Port Number] and [Operation Time-Out], if WebDAV port is disabled.
To configure [Port Number] and [Operation Time-Out], enable port status and reboot the
machine, and then configure [Port Number] and [Operation Time-Out].
Port Number
Enter a port number for WebDAV from 1 to 65535.
The default value is 80.
Important • Do not use the numbers assigned to the other ports.
Operation Time-Out
You can enter a operation time-out period between 1 and 65535 seconds in 1 second
increments.
ThinPrint
Port Status
You can use the machine for print in the ThinPrint.print environment. The machine
decompresses and prints the compressed print data sent from the print server.
Select [Enabled] when you use ThinPrint.
Port Number
Enter a port number for ThinPrint from 1 to 65535.
The default value is 4000.
Important • Do not use any numbers assigned to the other ports.
Note • ThinPrint is available when the communication protocol uses IPv4.
• The maximum of three connections are possible at a time.
Protocol Settings
Set the parameters required for communications. In [Protocol Settings], you can set the
following items.
Ethernet Rated Speed
Set the communication speed for the Ethernet interface.