Setup
249
Tools
5
1 Select [Print Cover Page].
2 Select [Comments].
3 Select any comment from the list of
comments displayed under [Recipient's
Comment] and [Sender's Comment].
Note • Select [ ] to display the previous screen
or [ ] to display the next screen.
4 Select [Save]. The image of the Fax Cover
Page is displayed.
5 Select [Save].
Maximum Image Size
Select the maximum image size from [A3], [B4], or [A4] to match the recipient's paper size or
available profile.
Delay Start
Set whether or not to use a delayed start transmission.
If the machine's system clock is set to the 24-hour display, [AM] and [PM] do not appear. For
information on the system clock, refer to "Time" (P.132).
Remote Folder
Select whether or not to send a fax or an Internet fax to a recipient's folder. To use folder
communications, you must obtain the recipient's folder number and passcode in advance.
1 Select [On].
2 Enter a recipient's folder number with the
numeric keypad.
3 If a passcode is set, enter the passcode with
the numeric keypad.
Note • If no passcode is set, leave the text boxes
blank and select [Save].
F Code
Select whether or not to use F code communications.
F Code is the transmission procedure set by the Communications and Information Network
Association of Japan and is the T.30 (communication protocol) method for using sub-
addresses that are standardized by the ITU-T.
For F code (sub address) and password, you can use up to 20 digits 0 to 9, ∗, and #.
To Next Page
Loading...
