15 Appendix
610
Appendix
15
159 (Scaling) Sets whether the original size is enlarged or reduced so that the
document size fits the paper size.
[0] : OFF
[1] (Default) : ON
160 (Scaling
mode)
Selects the document size for auto scaling: A series paper (A0, A1, A2,
A3, A4, and A6) or the active coordinate area which is determined
accordance with the setting selected in [Area Determination Mode].
[0] (Default) : Paper Size
[1] : Active Coordinate Area
Note • [Active Coordinate Area] can be selected only when [Auto layout] is
set to [ON]. When [OFF] is selected, [Scaling mode] becomes [Paper
Size].
• The setting of the scaling mode is valid when [Document size] is set
to [Auto].
161 (Active
area
determination
command)
Sets the method to obtain the active coordinate area when auto scaling is
being used.
[0] (Default) : Auto
[1] : PS
[2] : IW
[3] : IP
[4] : Adapted
Note • The setting of the active area determination command is valid when
[Document size] is set to [Auto].
162 (Paper
margin)
Sets the paper margin when auto scaling is being used.
[0] - [99] (Default: 0) : 0 to 99 mm
Note • The setting of the paper margin is valid when [Document size] is set
to [Auto].
163
(Image
enhancement)
Sets whether to perform image enhancement, which artificially increases
the resolution of an image and smooth its edges.
[0] : OFF
[1] (Default) : ON
Stapling 164 Sets the stapling position.
[0] (Default) : None
[1] : Top Left
[2] : Top Double
[3] : Top Right
[4] : Left Double
[5] : Right Double
[6] : Bottom Left
[7] : Bottom Double
[8] : Bottom Right
[9] : Center
Manual feed tray
check indicator
165 [0] : None
[1] (Default) : Yes
Punching 166 Select the position for punching holes.
[0] : None
[1] (Default) : Top
[2] : Bottom
[3] : Left
[4] : Right
Number of holes 167 Select the number of punch holes.
[0] (Default) : 2 holes
[1] : 3 holes
[2] : 4 holes
Parameter Item No. Value
To Next Page
Loading...
