Connectivity & Network Setup
175
Tools
5
îš„Auto Eject Time
Configure the time that the data so far received by the machine will automatically be printed
since data is no longer sent to the printer.
You can enter a time between 5 and 1275 seconds in 5 seconds increments.
îš„Adobe Communication Protocol
z
Standard
Select this when the output protocol of the print driver is in the ASCII format.
z
Binary
Select this when the output protocol of the print driver is in the BCP format.
z
TBCP
Select this when the output protocol of the print driver is in the TBCP format.
îš„Bi-directional Communication
Specifies whether or not to allow bi-directional communications.
USB
îš„Port Status
Select [Enabled] to use a USB interface.
îš„Print Mode
Select the printer language use on the machine. Selecting [Auto] enables the machine to
automatically determine and use the most suitable language to print data received from the
host device.
îš„PJL
PJL (Printer Job Language) is a job control language and a PJL command is data prepended
to the top of the print jobs. Usually select [Enabled].
îš„Auto Eject Time
Configure the time that the data so far received by the machine will automatically be printed
since data is no longer sent to the printer.
You can enter a time between 5 and 1275 seconds in 5 seconds increments.
îš„Adobe Communication Protocol
z
Standard
Select this when the output protocol of the print driver is in the ASCII format.
z
Binary
Select this when the output protocol of the print driver is in the BCP format.
z
TBCP
Select this when the output protocol of the print driver is in the TBCP format.
z
RAW
Select this when the output protocol of the print driver is in the ASCII or binary format.
The data is printed without being controlled by the Adobe communication protocol.
îš„PostScript Wait Timeout
The machine automatically terminates a connection when the machine does not receive data
for a certain period of time. When data is being printed with [RAW] is selected for [Adobe
Communication Protocol], select [Disabled] if you want to use the time period set in [Auto
Eject Time] or select [Enabled] if you want to use the timeout period of PostScript.
LPD
îš„Port Status
Select [Enabled] to use LPD.
To Next Page
Loading...
Need help?
General
