To Next Page

To Previous Page

Installation Procedure

343

Using the Server Fax Service

Installation Procedure

Installation Overview

This section describes the configuration procedure to use the Server Fax feature on the

machine.

The following shows the reference section for the configuration procedures.

Step 1 Fax Settings................................................................................................................... 343

Step 2 Setting the Server Fax Feature ...................................................................................... 344

Step 1 Fax Settings

If your machine does not support the Fax feature and supports the Server Fax feature

only, the Server Fax feature will be enabled automatically.

If your machine supports both the Fax and Server Fax features, manually switch to the

Server Fax feature.

The following procedure explains how to switch to the Server Fax feature on

CentreWare Internet Services.

For information on how to use CentreWare Internet Services, refer to "Configuring Machine Settings

Using CentreWare Internet Services" (P.277)

Note • You can switch to the Server Fax feature also on the machine's Control Panel.

1 Start a web browser.

2 Enter the machine's IP address or the Internet address into the address box on the

browser, and then click [Enter].

Example of the IP address entry

http://192.168.1.1/ (IPv4)

http://[2001:DB8::1234] (IPv6)

Example of the Internet address entry

http://myhost.example.com/

Note • When specifying a port number, add ":" and the port number to the end of the Internet

address.

3 Click the [Properties] tab.

4 Click [ ] on the left of [Services] to display the items in the folder.

5 Click [ ] on the left of [Fax] to display the items in the folder.

6 Click [Fax Settings].

7 On the [Fax Settings] screen, select [Scan to Fax Server] under [Fax Service].

8 Set the values as the machine's setting values.

1) Click [Apply].

2) The right frame on the web browser will change to the machine reboot display.

3) Click [Reboot Machine]. The machine reboots and the setting values are enabled.

Fuji Xerox DocuCentre-IV C5570 Administrator's Guide

Other manuals for Fuji Xerox DocuCentre-IV C5570