52 3 Print
3. Print the odd-numbered pages (side 2).
Remove the stack of the printed output and
flip the stack over.
Insert one sheet at a time into the manual
feeder with the blank side facing down,
starting from the sheet on top of the stack
that you have flipped over.
Note
• Warped or curled prints can cause paper jams.
Straighten them before loading them.
4. The message changes to [Press SET].
Press the <Eject/Set> button.
The printer starts printing odd-numbered
pages in the order of page 1 (on the
reverse side of page 2), page 3 (on the
reverse side of page 4), then page 5 (on the
reverse side of page 6).
Manual 2-sided Printing from the Tray 1
The following explains how to print a 2-sided job using the tray 1.
The procedure uses a six-page document as an example.
Note
• You cannot print on both sides of the paper if the document consists of various sizes of paper.
• For information on how to load paper in the tray 1, refer to " Loading Paper in the Tray 1" (P. 76).
• If a paper jam occurs when performing 2-sided printing, reload the paper in the tray 1. For more
information, refer to "A.6 Handling Paper Jams When Performing Manual 2-sided Printing" (P. 190).
1. The even-numbered pages are printed on
the front side (side 1) of each sheet in the
order of page 6, page 4, then page 2. The
messages shown on the right appear when
the even-numbered pages have been
printed.
2HAII 5-6
Tray 1 with
Print-side Down
One Side Printed
Load Paper in
To Next Page
Loading...
Need help?
General
