Level 1 Level 2 Description
PCL emulation Table Print
Print the code table.
Auto LF
ON: CR -> CR+LF, OFF: CR -> CR
Auto CR
ON: LF -> LF+CR, FF -> FF+CR, or VT -> VT+CR
OFF: LF -> LF, FF -> FF, or VT -> VT
Auto WRAP
Choose whether a line feed and carriage return will happen when the
machine reaches the right margin.
Auto SKIP
Choose whether a line feed and carriage return will happen when the
carriage position reaches the bottom margin.
Left Margin
Set the left margin at column 0 to 70 columns at 1 cpi.
Right Margin
Set the right margin at column 10 to 80 columns at 1 cpi.
Top Margin
Set the top margin distance from the top edge of the paper.
Bottom
Margin
Set the bottom margin distance from the bottom edge of the paper.
Lines
Set the number of lines on each page.
Tray Command
Select this setting if a tray mismatch appears when you use the HP
drivers.
PS3 emulation
(Available only for certain
models)
Error Print
Choose whether the machine prints the error information when errors
occur.
[Network]
For wired and wireless network models
Level 1
Level 2 Level 3 Level 4 Descriptions
Wired LAN TCP/IP Boot Method
- Choose the IP method that best suits your
needs.
IP Address
- Enter the IP address.
Subnet Mask
- Enter the Subnet mask.
Gateway
- Enter the Gateway address.
Node Name
- Enter the Node name.
WINS Config
- Select the WINS configuration mode.
WINS Server Primary
Specify the IP address of the primary WINS
server.
Secondary
Specify the IP address of the secondary WINS
server.
DNS Server Primary
Specify the IP address of the primary DNS
server.
Secondary
Specify the IP address of the secondary DNS
server.
APIPA
- Allocate the IP address from the link-local
address range automatically
1
.
IPv6
- Enable or disable the IPv6 protocol.
Ethernet
- - Choose the Ethernet link mode.
Wired Status
- - Display the Ethernet link status.
MAC Address
- - Display the MAC address of the machine.
Set to Default
- - Restore wired network settings of your machine
to the factory settings.
237
To Next Page
Loading...
Need help?
General
