3
1. When you turn on or restart the computer there is a
beep and/or the following message appears on the
screen:
Error message - please run SETUP
program Press <F1> key to continue,
<F2> to run SETUP
2. If an error message is displayed on the screen, and
you want to continue with the boot process and start
the operating system anyway, press the [F1] key.
3. If an error message is displayed on the screen, and
you want to enter the setup utility, press the [F2]
key.
4. When the setup utility starts with a fault present, the
system displays the following message:
Warning!
Error message
[Continue]
5. Press any key to enter the setup utility. The system
will then display the Info Menu with current param-
eters values.
If your notebook emits a series of beeps that
sounds like a code and the display is blank,
please refer to the Troubleshooting Section in
the system User’s Guide. The Troubleshoot-
ing Section includes a list of error messages
and their meanings.
If your data security settings require it, you
may be asked for a password before the
operating system will be opened.
Info Menu
To Next Page
Loading...
