What to do if my Fujitsu LIFEBOOK A550 cannot be started?
S
Sean FisherAug 16, 2025
If the notebook cannot be started, check whether the battery is installed correctly in its compartment and switch the notebook on. If the battery is dead, charge the battery, insert a charged battery, or connect the mains adapter to the notebook. Also, check whether the mains adapter is connected correctly to the notebook and switch the notebook on.
C
cassandrathompsonAug 22, 2025
What to do if Fujitsu LIFEBOOK A550 Laptop shows error message 'Operating system not found'?
M
Michael ScottAug 22, 2025
If you encounter the error message "Operating system not found" on your Fujitsu laptop, check in the BIOS Setup to ensure your hard disk has been set correctly. Also, make sure that the operating system is installed on the corresponding drive.
A
Anthony SuarezAug 25, 2025
Why is my printer not printing from my Fujitsu LIFEBOOK A550?
J
johnwolfeAug 26, 2025
If the printer does not print from your Fujitsu laptop, first ensure that the printer is switched on and ready for operation. Next, check that the data cable connecting the notebook to the printer is properly connected. Finally, ensure that the correct printer driver is loaded; refer to the printer documentation for assistance.
Q
qwebsterAug 28, 2025
How to fix 'System CMOS checksum bad' error on Fujitsu LIFEBOOK A550?
T
thompsoncarolAug 28, 2025
If you receive the error message: 'System CMOS checksum bad - default configuration used' on your Fujitsu laptop, switch the notebook off, then switch it back on. Press the F2 key to access the BIOS Setup. In the BIOS Setup, select the Exit menu, then select the entry Load Setup Defaults. Select OK and press the Enter key.
M
marymayerAug 31, 2025
How to improve LCD screen readability on Fujitsu Laptop?
C
Cole MartinezAug 31, 2025
If the LCD screen of your Fujitsu laptop is difficult to read, it may be due to reflected glare. Try turning the notebook or altering the tilt of the LCD screen. You can also increase the brightness of the screen.
A
Ashley RobertsSep 3, 2025
How to resolve 'Failure Fixed Disk n' error on Fujitsu Laptop?
D
David RobbinsSep 3, 2025
If you receive the error message "Failure Fixed Disk n" on your Fujitsu laptop, the settings of the hard disk drive are incorrect. Start the BIOS Setup (Primary Master submenu) and select the correct settings.
T
Tyler GutierrezSep 5, 2025
What does 'Extended memory failed at offset: xxxx' mean on Fujitsu LIFEBOOK A550?
D
Deborah GrantSep 6, 2025
If you see the error message "Extended memory failed at offset: xxxx" when using your Fujitsu laptop, it indicates an error during extended memory testing at the specified address. Check whether the additional memory module has been inserted correctly.
B
brittanyvargasSep 8, 2025
Why does my Fujitsu Laptop type numbers instead of letters?
R
Rachael HardySep 9, 2025
If, when entering characters on the keyboard of your Fujitsu device, only numerals are written, it means the virtual numeric keypad is activated. Press the Num key to deactivate it.
T
Thomas TuckerSep 12, 2025
How to fix 'Keyboard controller error' on Fujitsu Laptop?
S
Samantha JenkinsSep 12, 2025
To resolve a 'Keyboard controller error' on your Fujitsu notebook, switch the notebook off with the ON/OFF switch, wait 3 - 5 seconds, and switch the notebook on again.
J
Jacob BoyleNov 18, 2025
What to do if the external monitor remains blank with Fujitsu Laptop?
R
richard88Nov 18, 2025
If the external monitor is not displaying anything, first ensure it is switched on. If it is on, pressing any key can resume from power saving mode. Also, verify that the brightness isn't set too low. If these steps don't work, the screen output may be set to the notebook's LCD screen; in this case, press the key combination to switch the screen output. Finally, check that the monitor's power and data cables are properly connected to both the monitor and the Fujitsu laptop. If not, switch off the external monitor and the notebook, check whether the power cable is plugged properly into the external monitor and into the power socket, check whether the data cable is properly connected to the notebook and the external monitor (if it is plugged in with a connector), then switch on the external ...