7. Press the
button once to transmit the function setting information. 1 short beep will be emit-
ted from the indoor unit or the IR receiver when the signal is received correctly. If wrong code is
set, no beep sound will be emitted.
NOTE:
Press
button within 30 seconds after pressing MODE button.
For the function details, refer to Chapter 8-8. "Function details" on page 183.
8. Exit the function setting mode by pressing the RESET button.
- 170 -
8-5. Indoor unit (setting by wireless remote controller) 8. Function settings
SYSTEM
DESIGN
SYSTEM
DESIGN
To Next Page
Loading...
Need help?
General
