16) Heat pump backup setting
Enables or disables the heat pump backup instruction from the outdoor unit.
This function will be usable provided that the corresponding outdoor unit is connected.
Function number Setting value Setting description Factory setting
72
00 Disable ♦
01 Enable
17) Emergency heat
Enables or disables emergency heat input.
Function number Setting value Setting description Factory setting
73
00 Disable ♦
01 Enable
NOTE: When this function is used, IR receiver unit is necessary.
18) Fan delay time
Sets the fan delay time when the heater is turned off.
Function number Setting value Setting description Factory setting
74
00 1 minute ♦
01 50 seconds
02 40 seconds
03 30 seconds
19) External heater use in defrosting
Enables or disables external heater use in defrosting.
NOTE: Inappropriate heater selection may cause cold air in defrosting.
Function number Setting value Setting description Factory setting
75
00 Disable ♦
01 Enable
1-2. Function settings by using remote controller - (05-8) - 1. Function settings (For indoor unit)
FIELD
WORKING
FIELD
WORKING
To Next Page
Loading...
Need help?
General
