¢ Setting method
1. Be sure to disconnect the power supply or turn off the breaker.
2. Change the DIP switch setting according to the required setting.
• Various settings can be adjusted by changing DIP switches and push switches on the
board of the outdoor unit.
• The printed characters for the LED display are shown below.
DIP switch part
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
PUMP DOWN
1WS
TEST RUN
SET1
SET1-1
HEAT
COOL
SET2 SET3
FEDC
MONITOR
ERROR
BA
POWER
MODE
(
1
) (
2
) (
3
)
SW1
LED display part
2-1. Setting methods
- (05-11) - 2. Function settings (For outdoor unit)
FIELD
WORKING
FIELD
WORKING
To Next Page
Loading...
Need help?
General
