En-7
AIR CONDITIONER Wall Mounted Type
OPERATING MANUAL
Following 2 types of air cleaning ¿ lters are used in this product.
When you replace them, purchase dedicated air cleaning ¿ lters for this
product.
APPLE-CATECHIN FILTER: UTR-FA16
(1 sheet)
With using static electricity, puri¿ es the air by removing ¿ ne particles
or dust such as tabacco smoke or plant pollen.
• This ¿ lter is disposable. Do not wash or reuse it.
• Once you open the package, use it as soon as possible. The
cleaning effect is reduced if the ¿ lter is left the package opened.
• Replace the ¿ lter once every 3 months under normal use.
• With setting the fan speed high, the air cleaning effect increases.
ION DEODORIZATION FILTER (light blue): UTR-FA16-2
(Light blue, 1 sheet)
Contained super micro-ceramic particles produce negative air ions,
that is considered to have deodorizing effect, absorb and reduce
room smell.
• To maintain the deodorizing effect, clean the ¿ lter once every 3
months as follows:
1. Remove the ion deodorization ¿ lter.
2. Flush the ¿ lter with high-pressure hot water until the surface of
the ¿ lter is covered with water.
3. Wash the ¿ lter gently with diluent nuetral detergent. Do not wash
it by wringing or rubbing to prevent reducing the deodorizing
effect by damage.
4. Rinse the ¿ lter well with water À ow.
5. Dry the ¿ lter throughly in shaded place.
6. Reinstall the ion deodorization ¿ lter to the indoor unit.
• Replace the ¿ lter once every 3 years under normal use.
After extended non-use of the unit
If you have shut down the indoor unit for 1 month or more, perform the
FAN operation for half a day to dry the internal parts throughly before
you perform normal operation.
Additional inspection
After long period of use, accumulated dust inside the indoor unit may
reduce the product performance even if you have maintained the unit
with instructed daily care or cleaning procedures written in this manual.
In such a case, the product inspection is recommended.
For more information, consult authorized service personnel.
Replacing the air cleaning ¿ lter
1
Remove the air ¿ lter. (Refer to step 1 in “Replacing the air ¿ lter”.)
2
Release 2 latches
a
of the ¿ lter holder, and turn over the holder
in direction of arrow
b
.
Remove the soiled air cleaning ¿ lter
c
.
Note:
Air cleaning ¿ lter is attached on each air ¿ lter.
a
a
b
c
3
Attach new or maintained air cleaning ¿ lter
d
to the ¿ lter holder.
New air cleaning ¿ lter can be attached to either of the right holder
or the left holder.
d
4
Latch 2 corners of the ¿ lter holder
e
to the air ¿ lter ¿ rmly.
e
e
5
Reinstall the air ¿ lter. (Refer to step 6 in “Cleaning the air ¿ lter”.)
6
Close the intake grille ¿ rmly.
(Refer to step 4 in “Cleaning the intake grille”.)
Care and Cleaning
To Next Page
Loading...
Need help?
General
