12
10ºC HEAT OPERATION
• The room temperature can be maintained at 10°C by pressing the 10°C HEAT button
(Fig.6 O) so as to prevent the room temperature from falling too far.
To use 10ºC HEAT OPERATION
Press the 10ºC HEAT button (Fig.6 O)
To stop 10ºC HEAT OPERATION
Press the START/STOP button (Fig.6 T)
Then the operation stops.
About the 10ºC HEAT OPERATION
• The Heating mode will not operate if the room temperature is high enough.
While 10ºC HEAT OPERATION is in
progress, the following operations/
features cannot be used
• TIMER
• SLEEP
• FAN SPEED
• SWING
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2 2) on the main unit
control panel.
To stop operation, press the MANUAL AUTO button (Fig. 2 2) once again.
(Controls are located inside the Open Panel)
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Control Unit is lost or otherwise unavailable.
● When the air conditioner is operated
with the controls on the Main Unit, it
will operate under the same mode as
the AUTO mode selected on the Re-
mote Control Unit (see page 7).
● The fan speed selected will be “AUTO”
and the thermostat setting will be
standard.(24
°C)
To Next Page
Loading...
