Fujitsu ASUH12LPAS User Manual

19) Standby time for auxiliary equipment operation
Sets the standby time until the auxiliary equipment operation starts during primary equipment opera-
tion.
For details, refer to “External input and output" for each product type.
Function number Setting value Setting description Factory setting
71
00 Disable ♦
01 1 minute
02 2 minutes
• •
• •
• •
98 98 minutes
99 99 minutes
99 99 minutes
20) Heat pump backup setting
Enables or disables the heat pump backup instruction from the outdoor unit.
This function will be usable provided that the corresponding outdoor unit is connected.
Function number Setting value Setting description Factory setting
72
00 Disable ♦
01 Enable
21) Emergency heat for external output terminal
Enables or disables emergency heat input.
Function number Setting value Setting description Factory setting
73
00 Disable ♦
01 Enable
NOTE:
When this function is used, IR Receiver Unit is necessary.
22) Fan delay time
Sets the fan delay time when the heater is turned off.
Function number Setting value Setting description Factory setting
74
00 1 minute ♦
01 50 seconds
02 40 seconds
03 30 seconds
23) External heater use in defrosting
Enables or disables external heater use in defrosting.
NOTE: Inappropriate heater selection may cause cold air in defrosting.
Function number Setting value Setting description Factory setting
75
00 Disable ♦
01 Enable
- 216 -
16-6. Function details 16. Function settings
MULTI-SPLIT TYPE 5-unit type MULTI-SPLIT TYPE 5-unit type

Fujitsu ASUH12LPAS Specifications

General

Brand	Fujitsu
Model	ASUH12LPAS
Category	Air Conditioner
Language	English