En-7
To Change the Fan Speed
Press the FAN CONTROL button (Fig. 5 L).
Each time the button is pressed, the fan speed changes in the following order:
AUTO HIGH MED LOW
About three seconds later, the entire display will reappear.
When the FAN CONTROL is set to AUTO:
COOL : Operation begins and as the room temperature approaches that of the
thermostat setting, the fan speed switches to the low setting.
* HEAT : The fan operates at low speed at the beginning of operation or otherwise
when the temperature of the emitted air is relatively low; the fan speed
increases as the temperature of the emitted air rises.
As the difference between the thermostat setting and actual room temperature is
reduced, the fan speed becomes slower.
To Stop Operation
Press the START/STOP button.
The OPERATION indicator lamp (red) (Fig. 3 6) will light.
To Select Mode Operation
1
Press the START/STOP button (Fig. 5 M).
The indoor unit’s OPERATION indicator lamp (red) (Fig. 3 6) will light.
The air conditioner will start operating.
2
Press the MASTER CONTROL button (Fig. 5 H) to se-
lect the desired mode.
Each time the button is pressed, the mode will change in the following
order:
AUTO COOL DRY
*HEAT FAN
About three seconds later, the entire display will reappear.
ss s s
t
s
s
s
t
Example: When set to AUTO
Example: When set to COOL
Fan [HEAT & COOL MODEL (Reverse Cycle)]
● Use to circulate air through your room without changing
its temperature.
*Heating
● Use to warm your room.
● When Heating mode is selected, the air conditioner will
operate at very low fan speed for about 3 to 5 minutes,
after which it will switch to the selected fan setting. This
period of time is provided to allow the indoor unit to warm
up before begin full operation.
● When the room temperature is very low, frost may form
on the outside unit, and its performance may be reduced.
In order to remove such frost, the unit will automatically
enter the defrost cycle from time to time. During defrost
cycle, the red OPERATION indicator will flash, and the
heat operation will be interrupted.
Cooling
● Use to cool your room.
Drying
● Use for gently cooling while dehumidifying your room.
● You cannot heat the room during Drying mode.
● During Drying mode, the unit will operate at low speed;
in order to adjust room humidity, the indoor unit’s fan
may stop from time to time. Also, the fan may operate at
very low speed when detecting room humidity.
● The fan speed cannot be changed manually when Drying
mode has been selected.
Fan [COOLING MODEL]
● When using a space heater to heat the room, using the
air conditioner’s Fan setting will help prevent warm air
from collecting near the ceiling, and thus assist in distrib-
uting warm air evenly throughout the room.
● Fan operation will begin automatically when the room
temperature rises above the set temperature, and stop
when the temperature falls below the set temperature.
● If the air emitted from the unit feels too cold, increase the
temperature setting.
About Mode Operation
To Next Page
Loading...
Need help?
General
