En-5
5. AIRFLOW SETTINGS
5.1. Fan speed setting
Press to control the fan speed.
The fan speed changes as follows.
(Auto) (High) (Med) (Low) (Quiet)
When
is selected, the fan speed depends on the operating
condition.
5.2. Airow direction setting
range”.
■
Vertical airow direction setting
Press
■
Horizontal airow direction setting
CAUTION
stopped completely.
Adjust two knobs by hand.
■
Swing operation setting
Press to start/stop the Swing operation.
NOTES: The Swing operation may stop temporarily when the indoor
unit fan is rotating at very low speed or is stopped.
6. TIMER OPERATIONS
NOTES: When [
] indicator on the indoor unit blinks, set the clock
and timer again. This blinking shows that the internal clock go
wrong due to an interruption of the power supply.
6.1. On timer or O timer
The On timer starts the operation at your desired time.
1.
When you use the On timer, press .
.
2. Press
Pressing the button: The time will change by +5/-5 minutes.
Pressing and holding down the button: The time will change by
•
while is shown
on the remote controller display.
The indicator will disappear.
NOTES
6.2. Program timer
timer.
1.
timer”).
The timer setting changes to the Program timer
automatically.
The order of the timer operation is displayed as follows:
Timer Indicator on the remote controller display
NOTES:
Program timer is canceled.
4. BASIC OPERATIONS
■
3 steps to start operation
1. Press
to start or stop the operation.
2. Press
to select the operation mode.
The operation mode changes as follows.
AUTO COOL DRY FAN HEAT
3. Press
to set the desired temperature.
Temperature setting range
Auto/Cooling/Dry
Heating
NOTES:
• In the Cooling or Dry mode, set the temperature lower than the
current room temperature.
• In the Cooling mode, the indoor unit fan may stop from time to time
to perform Fan control for energy saving that enables power-saving
operation by stopping the rotation of the indoor unit fan when the
outdoor unit is stopped.
In initial setting, this function is activated.
To deactivate the function, consult the installer or authorized service
personnel.
• In the Heating mode,
- set the temperature higher than the current room temperature.
- at the beginning of the operation, the indoor unit fan rotates at very
low speed for 3-5 minutes.
- the Automatic defrosting operation overrides the Heating operation
when necessary.
• In the Fan mode, temperature control is not available.
■
Airow direction range
Vertical airow direction
Change by
⇄
2
⇄
3
⇄
⇄
5
⇄
6
Swing operation by
Cooling, Dry
Heating 3 6
Fan * or 3 6
the Swing operation.
NOTES:
•
•
a while from the start of the operation.
•
position 3 automatically.
• When using the mobile app (optional wireless LAN control is
9387858020-02_OM.indb 5 03-Sep-21 13:52:46
To Next Page
Loading...
Need help?
General
