En-12
Temporary deactivation of wireless LAN
NOTES: If you do not press any buttons of the remote controller for 60
seconds, the remote controller display will return to the original
display.
1. Press
until only the clock is displayed on
the remote controller display.
2. Press down
on the remote controller
for more than 5 seconds.
will be displayed on the remote controller
display.
3. Select
using on the remote
controller. *
4. Press
.
[
* If you want to activate wireless LAN again, select in step 2.
Initialization (reset)
Initialize (reset) this product in the following situations:
• Changing the wireless router
• Disposing this product
• Transferring this product to a third party
Unregister the air conditioner
Unregister the air conditioner by using the mobile app. (Refer to the
operation manual of the mobile app for details.)
Initialization of the WLAN adapter
NOTES: If you do not press any buttons of the remote controller for 60
seconds, the remote controller display will return to the original
display.
1. Press
until only the clock is displayed
on the remote controller display.
2. Press down
on the remote controller
for more than 5 seconds.
will be displayed on the remote controller
display.
3. Select
using on the remote
controller.
4. Press
.
on the remote controller display will blink.
5. Press
.
[
To continue use
If you or third party wishes to continue use of the product, follow the
procedures in “Air conditioner registration (pairing of WLAN adapter)” to
NOTES: Wireless LAN setup is not possible if the previous owner did
not unregister or initialize this product. In this case, please
contact your authorized service personnel.
12.3. Multi-type air conditioner
NOTES:
Depending on model, this function cannot be used. For details,
please consult authorized service personnel.
This indoor unit can be connected to a multi-type outdoor unit.
The multi-type air conditioner allows multiple indoor units to be
operated in multiple locations. The indoor units may be operated
simultaneously, in accordance with their respective output.
Simultaneous Use of Multiple Units
be operated simultaneously, but when 2 or more indoor units of the
same group are operated simultaneously, the heating and cooling
Accordingly, when you wish to use more than 1 indoor unit for cooling
at the same time, the use should be concentrated at night and other
times when less output is required. In the same way, when multiple
units are used simultaneously for heating, it is recommended that they
be used in conjunction with other auxiliary space heaters, as required.
the rooms and the number of persons present may also result in
output provided by your units, and use the units in the way that best
matches your family's lifestyle.
heating during simultaneous operation, we recommend that you stop
simultaneous operation of the multiple units.
If the indoor unit is instructed to do an operating mode that it cannot
perform, [
]-
Heating mode and Cooling mode (or Dry mode)
Heating mode and Fan mode
Cooling mode and Dry mode
Cooling mode and Fan mode
Dry mode and Fan mode
The operating mode (Heating mode or Cooling (Dry) mode) of the out-
door unit will be determined by the operating mode of the indoor unit
the operating mode of the outdoor unit will not be determined.
For example, if indoor unit (A) was started in the Fan mode and then
indoor unit (B) was then operated in the Heating mode, indoor unit (A)
would temporarily start operation in the Fan mode but when indoor
unit (B) started operating in the Heating mode, [
] indicator for indoor
go into standby mode. Indoor unit (B) would continue to operate in
Heating mode.
9387602142-02_OM.indb 12 01/12/2022 13:04:01
To Next Page
Loading...
Need help?
General
