En-15
■
State of indicator lamps
: The instruction is relating to the WLAN control.
Lighting pattern: Blinking, Any state
State Causes and solutions
See
page
Automatic defrosting operation
⇒
Please wait until nishing the
defrosting (maximum of 15 minutes).
13
Filter indicator
⇒
Clean the air lter and reset the lter
sign.
12
Error code display
⇒
Consult authorized service personnel.
-
Timer setting error because of Auto
restart
⇒
Reset the clock and timer settings.
13
Test run operation (for authorized
personnel only)
⇒
Press
to quit the test run.
3
The power to the wireless router is
not on.
-
⇒
Check that the power to the wireless
router is on.
There is a possibility that the WLAN
adapter is not properly connected
to the wireless router.
7
⇒
Disconnect the power supply to the
air conditioner (via breaker or plug),
and then re-connect.
The software of the WLAN adapter
is being updated.
-
During the air conditioner registration
(pairing of WLAN adapter)
9
Restricted function
13
■
Manual Auto operation and Filter indicator
reset
You can operate the air conditioner with on the
indoor unit.
Status Time to keep pressing Mode or operation
In operation More than 3 seconds Stop
Stopping 2 seconds or less Filter indicator reset
More than 3 seconds and
less than 10 seconds
Auto
More than 10 seconds
(Only for servicing.*
1)
)
Forced cooling
*1) To stop the forced cooling, press this button or
on the remote
controller.
(3 times)
(Fast)
(Slow)
9387858068-01_OM.indb 15 07-Oct-20 14:00:45
To Previous Page
Loading...
Need help?
General
