¢
UTY-RSNYM
Button name and function
During address setting mode, indoor unit reject the any operation command from remote controller.
Function number
Refer to Function details
Remote controller address
FAN button
Each time this button is
pressed, the fan setting
changes among “Remote
controller address,” “Function
number” and “Setting number.”
Setting number
Refer to Function details
START/STOP button
Transmits function setting
SET TEMP. “
p
” and “
q
” button
Switches the various numbers.
Function setting procedure
1. Connect the power supply of the outdoor unit.
2. Switch to the function setting mode.
To enter the function setting mode, hold down the 3 buttons of SET TEMP.
, SET TEMP.
and FAN at the same time for 5 seconds or longer.
Function setting mode initial display
3. Press the FAN button.
The Function number indicator flashes. Then, press either the SET TEMP.
button or the
SET TEMP. button to set up the function number.
- 301 -
14-4. Indoor unit (setting by simple remote controller) 14. Function settings
4-5 UNIT
MULTI-SPLIT TYPE
4-5 UNIT
MULTI-SPLIT TYPE
To Next Page
Loading...
Need help?
General
