23
Getting Started
Power Sources
Your Fujitsu LifeBook notebook has two possible power
sources: a Lithium ion battery or an AC adapter.
CONNECTING THE AC ADAPTER
The AC adapter provides power for operating your
LifeBook notebook and is used to charge the batteries.
Connecting the AC Adapter
1. Plug the DC output cable into the DC power jack of
your LifeBook notebook.
2. Plug the AC cable into the AC adapter.
3. Plug the AC cable into an AC electrical outlet.
(Figure 3-1)
Switching from AC Adapter Power to Battery Power
1. Be sure that you have a charged battery installed.
2. Unplug the AC adapter.
Figure 3-1. Connecting the AC Adapter 1
2
DC Power Jack
DC Output Cable
3
4
AC Adapter
AC Cable
1
2
3
4
■
When you run the N6200 Series Life-
Book on battery power, by default, the
CPU will slow down approximately by
half in order to optimize battery life.
This feature can be enabled or
disabled in the BIOS. Use an AC
Adapter whenever possible.
■
The Lithium ion battery is not charged
upon purchase. Initially, you will need
to connect the AC adapter to use your
LifeBook notebook.
N6220.book Page 23 Tuesday, September 27, 2005 5:11 PM
To Next Page
Loading...
