70
- Memory Upgrade Module
Removing a Memory Upgrade Module
THE MEMORY UPGRADE MODULE IS NOT SOMETHING YOU SHOULD ROUTINELY REMOVE FROM YOUR
NOTEBOOK. ONCE IT IS INSTALLED, YOU SHOULD LEAVE IT IN PLACE UNLESS YOU WANT TO INCREASE
SYSTEM MEMORY CAPACITY.
1 Perform steps 1 through 5 of Installing a Memory
Upgrade Module.
2 Pull the clips sideways away from each side of the
memory upgrade module at the same time.
3 While holding the clips out, remove the module
from the slot by lifting it up and pulling towards the
rear of your LifeBook notebook.
(Figure 37)
4 Store the memory upgrade module in a static
guarded sleeve.
5 Replace the cover by following steps 9 and 10 of
Installing a Memory Upgrade Module.
Figure 37. Removing a Memory Upgrade Module
A
FTER INSTALLING YOUR ADDED MEMORY MODULE, YOU MUST RESET THE POWER PLAN PARAMETERS
IN ORDER FOR THE SAVE-TO-DISK MODE TO OPERATE PROPERLY ON YOUR LIFEBOOK NOTEBOOK. SEE
“H
IBERNATION (SAVE-TO-DISK) FEATURE” ON PAGE 45.
To Next Page
Loading...
