45. Connect the IO Board cable, the
Bluetooth cable, and the DC power
cable to the system board.
47. Place the upper case and
connect the ClickPoint button cable
and the speaker cable.
49. Extract 3 screws from the PCB.
51. Attach the 2 display cables to
the system board and the 2 antenna
Cables to the WLAN card.
46. Insert the WLAN card and secure
it with 1 screw.
48. Close the external VGA
connector cover and secure the
upper case with 4 screws.
50. Secure the display with 2 screws
in the hinge.
52. Tilt the display up and rotate it ¼
turn.
To Next Page
Loading...
