37. Insert the RJ45 connector and
cable into the lower case.
39. Insert the RJ11 Connector and IO
Board and secure the board with 4
screws.
41. Set the system board onto the
lower case and connect the LAN
cable.
43. Place the heat sink onto the
system board and secure it with 2
screws.
38. Insert the Bluetooth board and
secure it with 1 screw.
40. Insert 2 hex screws into the
external VGA connector.
42. Turn the system board over,
insert it into the lower case and
secure it with 3 screws.
44. Connect the fan’s cable to the
system board.
To Next Page
Loading...
