Wireless LAN User’s Guide
113
Unavailable
network connection
(continued)
Communication is
disconnected soon
after connection to
the access point
Incorrect setting of IP
address
Access control may
be disabled
If [Cable Disconnected] or [Media
Disconnected] is displayed without showing
IP address, check the setting of network
name (SSID) and network key. Also, set the
network authentication according to the
access point.
In case of Windows XP, check the setting of
“Enable network access control using IEEE
802.11X”.Refer to “Assigning parameters” on
page 99.
When restricting the access of wireless LAN
clients using IEEE802.11X authentication, put a
check mark on “Enable network access control
using IEEE 802.11X”.
When using at home, remove a check mark on
“Enable network access control using
IEEE802.11X”.
For the method of setting related with
IEEE802.11X authentication, refer to the
access point manual.
Problem Possible Cause Possible Solution
LB_GARLICS 09 (106-116) 21/7/03, 6:29 PM113
To Next Page
Loading...
