LifeBook S Series - Section 4
48
Memory Upgrade Module
Your Fujitsu LifeBook notebook comes with a
minimum of 256MB of high speed Double Data
Rate Synchronous Dynamic RAM (DDR
SDRAM), factory installed. To increase your
LifeBook notebook’s memory capacity, you may
install an additional memory upgrade module.
The memory upgrade must be a dual-in-line
(DIMM) SDRAM module. To ensure 100%
compatibility, purchase the SDRAM module only
from the Fujitsu store .
INSTALLING MEMORY UPGRADE
MODULES
1. Turn off power to your LifeBook notebook and
remove any power adapter (AC or adapter).
2. Make sure that all the connector covers are
closed.
3. Turn the notebook bottom side up, and
remove the screws of the memory upgrade
module compartment.
(Figure 4-8)
4. Remove the cover.
Figure 4-8. Opening the Memory Upgrade
Compartment
Figure 4-9. Installing a Second Memory
Module
Figure 4-10. Replacing the Memory
Compartment Cover
Do not remove any screws from the
memory upgrade module compartment
except the ones specifically shown in the
directions for installing and removing the
memory upgrade module.
The memory upgrade module can be
severely damaged by electrostatic
discharge (ESD). Be sure you are
properly grounded when handling and
installing the module.
5. Remove the memory upgrade module from
the static guarded sleeve.
6. Align the memory upgrade module with the
component side up. Align the connector edge
of the memory upgrade module with the
connector slot in the compartment.
7. Insert the memory upgrade module at a 45°
angle. Press the connector edge of the
module firmly down and into the connector
until it lodges under the retaining clip. You
will hear a click when it is properly in place.
(Figure 4-9)
8. Replace the cover.
(Figure 4-10)
9. Replace the screws.
The memory upgrade module is not
something you routinely remove from your
notebook. Once it is installed, you should
leave it in place unless you want to change
system memory capacity.
LB_GARLICS 04 (48-56) 21/7/03, 6:26 PM48
To Next Page
Loading...
