32
LifeBook S Series - Section 3
• [Fn+F6]: Pressing repeatedly will lower the
brightness of your display.
• [Fn+F7]: Pressing repeatedly will increase
the brightness of the display.
Using the Power Management Utility
(Windows 2000 only)
Adjusting the brightness using the Power
Management utility changes the setting
permanently.
1. Double-click the BatteryAid icon in the
lower right corner of your display. This will
open the BatteryAid Properties dialog box.
2. Select the Power Control tab and adjust your
LCD backlighting to the desired level.
3. Click OK or Apply to permanently change
the settings.
Display Panel
Your Fujitsu LifeBook notebook contains a display
panel that is backlit for easier viewing in bright
environments and maintains top resolution
through the use of activematrix technology.
OPENING THE DISPLAY PANEL
1. Press the Display Panel latch. This releases
the locking mechanism and raises the display
slightly.
2. Lift the display backwards, being careful not
to touch the screen, until it is at a comfortable
viewing angle.
(Figure 3-2)
ADJUSTING DISPLAY PANEL
BRIGHTNESS
Once you have turned on your LifeBook
notebook, you may want to adjust the brightness
level of the screen to a more comfortable viewing
level. There are two ways to adjust the brightness,
by using the keyboard or the power management
utility.
Using the Keyboard
Adjusting the brightness using the keyboard
changes the setting only temporarily.
Figure 3-2 Opening the Display Panel
When using AC power your brightness setting
is set to its highest level by default. When
using battery power your brightness setting
is set to approximately mid-level by default.
Display Panel Latch
LB_GARLICS 03 (29-38) 21/7/03, 6:24 PM32
To Next Page
Loading...
