18
LifeBook T Series BIOS
SECURITY MENU – SETTING THE SECURITY FEATURES
The Security menu allows you to set up the data security features of your notebook to fit your operating needs and to
view the current data security configuration. (See Navigating through the Setup Utility on page 2 for more information.)
The following tables show the names of the menu fields for the Security Menu and its submenus, all the options for
each field, the default settings and a description of the field's function and any special information needed to help
understand the field's use. The default condition is no passwords required and no write protection.
Figure 13. Security Menu
■
Remember your passwords! If you set and forget your User and Master hard disk passwords, Fujitsu
Computer Systems will not be able to reset it. You may lose data and have to replace your system
board or hard disk drive.
■
WARNING. VERY IMPORTANT if your hard disk drive is protected using a Full Disk Encryption (FDE)
"engine". FDE encrypts all data as it is written to the hard drive. When data is retrieved from the
hard drive, it is decrypted by the same engine. If you forget your hard disk security password on a
system with FDE, all data and applications on the hard drive will remain encrypted and will effec-
tively be lost. Be sure to remember your hard disk password.
■
Entering a password incorrectly 3 times in a row causes the keyboard and mouse to be locked out
and [System Disabled] to be displayed. If this occurs, restart the computer by turning off and on
the power with the power switch and use the correct password on reboot.
■
If you make an error when re-entering the password a Warning will be displayed. To try again press
[Enter], then retype the password, or press [Esc] to abort the password process.
■
If the Security Panel on Resume is Enabled and the Password on Boot is Disabled you will not have
to type your password upon resuming the system from the Suspend or Save-to-Disk modes. Power
Management Security will work only if Password boot is enabled.
F1 Help
ESC Exit
Select Item
Select Menu
-/Space
Enter
F9 Setup Defaults
F10 Save and Exit
Change Values
Select Sub-Menu
▲
Item Specific Help
Press <Enter> key to
set Supervisor Password
to enable any password
features.
Then password entry is
required to enter BIOS
Setup.
Supervisor Password Is: Clear
User Password Is: Clear
Set Supervisor Password [Enter]
Set User Password [Enter]
Minimum User Password Length: [0]
Password on Boot: [Disabled]
On Automatic Wake up: [Disabled]
KB Lock on Resume: [Disabled]
Boot from Removable Media: [All]
Flash Write: [Enabled]
Hard Disk Security
Owner Information
TPM (Security Chip) Setting
▲ ▲
▲
Phoenix SecureCore(tm) Setup Utility
Info System Advanced Security Boot Exit
To Next Page
Loading...
