33
- Display Panel
Using the System as a Tablet
If you would like to use the system as a tablet, perform the following steps.
1 Lift the display until it is perpendicular to the keyboard.
2 When the display is perpendicular to the keyboard, rotate it 180 degrees in either direction so that it is facing
backwards.
(Figure 10)
3 Holding the top edge of the display panel, pull it forward until it is lying nearly atop the keyboard.
IN THE FOLLOWING STEP, BE SURE TO POSITION THE DISPLAY PERPENDICULAR TO THE KEYBOARD,
OTHERWISE THE KEYBOARD OR DISPLAY COVER COULD GET SCRATCHED.
4 Push the latch towards the display (See “A” in
Figure 9). The top latch disappears, and the
bottom latch appears (See “B” in Figure 9). Lay
the display flush against the system so that the
latch rests in the slot in the battery pack. You can
now use the system as a tablet.
(Figure 12)
5 To return the system to notebook configuration,
repeat step 3 and 2. Be sure to turn the display in
the opposite direction when performing step 2.
Figure 9. Using the Display Latch
To Next Page
Loading...
