1
3
Installing hardware options
If hardware options have been purchased separately, install them before installing the Operating Sys-
tem.
In the following case, it is not required to install the hardware options.
- Custom Made Service
TX200 S2
1
Checking the items
supplied
Check the contents in the package using
the "Contents List".
If any items are missing, inform an ofce listed in
the "Contact Information".
n
PRIMERGY TX200 S2 Manuals
Manuals for this server can be accessed from the section below of the PRIMERGY Document and Tool CD (Disc 2).
[CD-ROM Drive] :\MANUAL\INDEX.PDF
Manuals can be displayed using Acrobat
®
Reader
®
or Adobe
®
Reader
®
. If using Acrobat
®
Reader
®
, use version 4.0 or later.
B7FH-2971-02EN-00
2
Reading and understand-
ing "Safety Precautions"
Before using this server, be sure to read and un-
derstand the attached "Safety Precautions".
Also check it when connecting, installing hardware options
and setting up this server.
n
Point to note before installing hardware
options
When installing hardware options, perform operations after
reading the following manuals.
"Chapter 7 Installing Hardware Options"
"PRIMERGY Server Books"/
"Supplement"
Install the OS before installing the following options.
Installing the OS after options have been installed will
cause installation operations to end in an error.
- Non-system hard disks
- External SCSI optional devices (Backup cabinet, DAT
unit, etc.)
n
Available hardware options and
installation locations
After installing hardware options, check that the order and
place of installation is correct and cables are correctly at-
tached.
To Next Page
Need help?
General