Fujitsu PRIMERGY TX200 S2 - Page 11

Max: 2 devices
Tape Drv DAT72 36GB internal
PG-DT501
SCSI Cable 1.54m
PG-CBLS023
Tape Drv LTO2 Ultrium2 200GB
PG-LT201
SCSI Ctrl U160
PG-128
Tape Drv VXA-2 80GB
PG-VX201
If you would like to order internal backup devices, please order necessary SCSI cards/SCSI cables according to the following table.
* When internal HDD Unit Bay Coversion kit (PG-BC102) is applied, internal backup devices can not be mounted on 5 inch bays.
*PRIMERGY SX10 is available for rack install type.
SCSI Ctrl U160
PG-128 SCSI Cable HDCI 1.5m PRIMERGY SX10
PG-CBLS001 PG-R1BC4
SCSI Cable HDCI 5m
PG-CBLS002
*Please find more information on the internal backup devices for PRIMERGY SX10
in Rackmount [Internal Backup Devices with PRIMERGY SX10 ]
Onboard SCSI (ChB)
SCSI Cable (PG-CBLS023)
not mounted
SCSI Card (PG-128)
SCSI Cable (PG-CBLS023)
PG-140D1
Type of HDD connection SCSI Array controller card
PG-142E3
mounted
Necessary SCSI cards/SCSI cables
for Internal Backup Devices
Tape Drv LTO2 Ultrium2
200GB
(PG-LT201)
RAID
SCSI
not mounted
mounted
Internal backup device
Internal backup device (PRIMERGY SX10)
PCI Bus
Onboard SCSI
Controller (Wide)
PRIMERGY TX200 S2
PCI Bus