EasyManua.ls Logo

Fujitsu PRIMERGY TX200 S7 - Storage, Controllers, and System Management

Fujitsu PRIMERGY TX200 S7
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TX200 S7 Operating Manual 17
Functional overview
Hard disk drives
For the server is available in two chassis variants:
For up to eight 3.5-inch SAS/SATA HDD
Up to four SAS/SATA HDD modules can be used in the standard HDD cage.
Each HDD module can accommodate a SAS/SATA HDD with a maximum
height of 1 inch. The module is connected to the SAS/SATA backplane
wirelessly. This allows HDD modules to be plugged in and pulled out easily.
Optionally, you can also install one of the following hard disk expansion
boxes:
4 x 3.5-inch HDD extension box for up to four additional 3.5-inch
SAS/SATA HDD modules and a slimline optical disk drive
2 x 3.5-inch HDD extension box for up to two additional 3.5-inch
SAS/SATA HDD module and a slimline optical disk drive
For up to sixteen 2.5-inch SAS/SATA HDD/SSD:
Up to eight SAS/SATA HDD/SSD modules can be used in the standard HDD
cage. Each HDD/SSD module can accommodate an SAS/SATA HDD/SSD
with a 2.5-inch format. The module is connected to the SAS/SATA
backplane wirelessly. This allows HDD/SSD modules to be plugged in or
pulled out easily.
Optionally, you can also install an HDD extension box (with up to eight 2.5-
inch SAS/SATA HDD/SSD modules). An additional SAS controller must be
installed in order to control the hard disk drives in this expansion box. The
HDD in this expansion box are controlled by a SAS expansion card or by a
second 8-Port RAID Controller.
I Mixed configurations with Eco SATA drives and SAS drives are not
allowed. 2.5-inch SAS drives and 2.5-inch BC SATA drives can be mixed,
but not used in one logical RAID volume.
Onboard SAS/SATA controller
A SAS/SATA controller is integrated on the system board; up to four SAS or
SATA hard disk drives can be connected to the controller. The LSI Embedded
MegaRAID software (Software RAID) supports RAID levels 0, 1 and 10. The
SAS functionallity needs to be enabled separately by using a ROM1 SCU Key.
For more information on configuring the controller, see section "Configuring the
onboard SAS/SATA controller" on page 78.

Table of Contents

Other manuals for Fujitsu PRIMERGY TX200 S7

Related product manuals