TX200 S7 Operating Manual 19
Functional overview
Accessible drives / components
The server has three 5.25-inch bays.You can use these bays as follows:
– Optical disk drives or backup drives.
– Multibay for a slimline optical disk drive and a Server View Local Service
Display (LSD); occupies one bay.
– 4 x 3.5-inch HDD extension box for up to four additional 3.5-inch SAS/SATA
HDD modules and a slimline optical disk drive; occupies three bays.
– 2 x 3.5-inch HDD extension box for up to two additional 3.5-inch SAS/SATA
HDD modules and a slimline optical disk drive; occupies two bays.
– 8 x 2.5-inch HDD extension box for up to eight additional 2.5-inch SAS/SATA
HDD modules; occupies two bays.
Power supply units (PSUs)
The power supply configuration depends on the base unit:
– a standard PSU (800 W)
– one hot-plug PSU (450 W or 800 W)
– two hot-plug PSUs for redundancy
The PSUs adjust automatically to any mains voltage in the range of 100 V -
240 V.
A mix of 450 W and 800 W hot-plug PSUs is not allowed. If one of two hot-plug
PSU is defective, the other guarantees unimpaired operation. The defective
power supply module can be replaced during operation (see the "PRIMERGY
TX150 S8 / TX200 S7 Server Upgrade and Maintenance Manual").
I Redundancy is only guaranteed, if the total maximum power of all low
power versions gets not exceeded. Power sharing under mix mode
operation is not guaranteed.
To Next Page
Loading...
