Fujitsu R407C User Manual

Error Code
Error Code
Error contents
Model information abnormal
No error
Power supply frequency abnormal
EEPROM access error
EEPROM deletion error
Room temperature themistor error
Indoor unit heat exchanger themistor
Indoor unit heat exchanger themistor
Indoor unit heat exchanger themistor
Blower temperature themistor error
Drain abnormal
Room temperature abnormal
Indoor unit fan error
Transmission error
Node setting error
Parallel communication error
5-3 REMOTE CONTROLLER
MASTER
CONTROL
FAN
CONTROL
TIMER
MODE
TEMP./DAY
SET TIME
CLOCK ADJUST
START/STOP
SET DAY OFF
ZONE ENERGY SAVE
MASTER
CONTROL
FAN
CONTROL
TIMER
MODE
TEMP./DAY
SET TIME
CLOCK ADJUST
START/STOP
SET DAY OFF
ZONE ENERGY SAVE
COOL
CLOCK
C
NON STOP
Outdoor unit error
(middle) error
(inlet) error
(outlet) error
05-05
Remote controller
address
SET
SET
Error Code
Remote controller
address
If there is a problem with the air conditioner it will stop
running and " EE:EE " will be displayed.
(1) If the operation lamp is on then press
button to turn it off.
(2) Press the
and the
buttons at the same time
for more than three seconds to start the self diagnosis
check.
An error code will be displayed display area.
(3) Press the
and the
buttons again for more than
three seconds to end the self diagnosis check.
Error code history can be displayed. Please refer to
"Installation Instruction Sheet" of the remote controller.
If there is a problem with the air conditioner, it will
stop running and " EE:EE " will be displayed instead
of the clock.
Error code displayed on wired or simple remote controller
(1) If the operation lamp is on then press START/
STOP button to turn it off.
(2) Press the SET TIMER button ( ) and SET
TEMP./DAY button ( ) at the same time for more
than three seconds to start the self diagnosis check.
An error code will be displayed in the clock display area.
(3) Press the SET TIMER button ( ) and SET
TEMP./DAY button ( ) again for more than three
seconds to end the self diagnosis check.
5-3-1 WIRED REMOTE CONTROLLER
5-3-2 SIMPLE REMOTE CONTROLLER
Error code history can be displayed when UTB- LB type
wired remote controllers is used.Please refer to
"Installation Instruction Sheet" of the controller.

Fujitsu R407C Specifications

General

Brand	Fujitsu
Model	R407C
Category	Air Conditioner
Language	English