Using the device
14 Fujitsu
Status Action Displays Description
300 long red
flashes
(approx.. 5
mins)
Fall / fall over alert detected
Alert detection －
10 long red
flashes
All other alert notification detected
Fall alert
deactivation
Press the power
button for 1
second
Alarm is turned
off
When the power button is pressed for 1
second an alert notification of a fall
detection will be cancelled by sending a
cancellation message to the gateway
Updating
Configuration
－ Stays lit Orange
The configuration within the Vital
Sensing Unit S is being updated
Flashes orange
3 times
The notification signal is being sent to the
gateway when the button(s) are pressed.
Notification button
For information on
how to use the
notification
buttons, see
chapter "
Notification
Button", Page 16
3 long orang
flashes
The notification signal w
as received by the
gateway when the button(s) were pressed.
The device takes approx. 30 seconds to start after the power is turned on. Do not press any
buttons at this time
Flash = every 0.5 seconds
Long Flash =every 1 second
To Next Page
Loading...
