Fujitsu UTY-RCRYZ1 - Comfort Airflow Function; Comfort Airflow Setting; Horizontal Airflow Direction Setting; Vertical Airflow Direction Setting

En-2
2. MAIN UNIT AND ACCESSORIES
The following installation parts are supplied. Use them as
required.
Name and Shape Q’ty Name and Shape Q’ty
Wired remote con-
troller
1
Screw (M3 ×16 mm)
For installing the
remote controller
2
Installation manual
(This manual)
1
Cable tie
For binding remote
controller and
remote controller
cable
1
Operating manual
1
3. ELECTRICAL REQUIREMENT
When connecting the remote controller use the following
wiring.
Cable type Size Remarks
Shielded cable
0.33 to 1.25 mm²
(22 to 16 AWG)
Non polar 2 core,
Twisted pair
Select a fl exible cable that can be bound using cable
ties from over the cable sheath inside this product.
Remote controller cable length: MAX. 500 m
4. SELECTING AN INSTALLATION
LOCATION
4.1. Dimensions and Name of parts
Remote controller Unit: mm
Hole × 4
(for M3 screws)
60.544
86
86
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
Hole: screw hole to set this product
(a) Display panel
(b) Wireless remote controller signal receiver
(c) Room temperature sensor (inside)
(d) [
]: Operation mode button
Set the operation mode. Refer to operating manual.
(e) [
]: Menu button
Selects one of the 3 functions below to use:
• Airfl ow direction louver setting
• Off Timer setting
• Filter sign reset
(f) [
] [ ]: Set temperature button
Set the operating temperature. Refer to operating
manual.
(g) [
]: Fan speed button
Set the fan speed. Refer to operating manual.
(h) [
]: Start/Stop button
The LED on the button turns on (green) while the
indoor unit is operating.
Screen display
Monitor Mode
(i) (j)
(l)
(k)
(n)
(m)
(i) Operation mode indicator: Refer to operating manual.
(j) Temperature indicator: Refer to operating manual.
(k) Fan speed indicator: Refer to operating manual.
(l) Airfl ow direction indicator: Refer to operating manual.
(m) Room temperature indicator: Refer to operating
manual.
(n) Set temperature indicator: Refer to operating manual.
“Monitor Mode” screen is the home screen of this unit.
Except for in the following cases, the screen will go back
to the “Monitor Mode” screen if there is no operation for
over 10 min. (Unsaved settings will be cancelled.)
• In Initial and maintenance settings
9373328483-02_IM.indb 29373328483-02_IM.indb 2 11/18/2019 2:04:34 PM11/18/2019 2:04:34 PM