１３ .COMPRESSOR removal
Precautions for exchange of Compressor.
Do not allow moisture or debris to get inside refrigerant pipes during work.
Procedure for Compressor removal.
Collect the refrigerant from the CHECK JOINT.
Start the following work after completely collecting the refrigerant.
Do not reuse the refrigerant that has been collected.
Remove the SENSOR (TEMP.DISCHARGE) Remove the COMPRESSOR COVER ④,
and the SENSOR. (TEMP.SUCTION) COVER⑤, and COVER ⑥
(※see chapter 25 and 26)
Remove the COMPRESSOR COVER ①,
COVER② , and COVER③.
Remove the nut. Remove the connectors.
Remove the TERMINAL COVER. [ S(U) : BLACK, R(V) : WHITE, C(W) : RED ]
Check
To Next Page
Loading...
