English
7
Turn on the display unit using the power switch (1) and check
to make sure that the power LED (2) is on, as shown below. If
not, repeat steps 2,3 and 4 or refer to the Troubleshooting
section of this guide.
Turn on the power to the computer. The picture will appear
within about 15 seconds. During its start-up the computer
recognizes the display automatically provided that the display
unit has been turned on. Adjust the picture to obtain optimum
picture quality. See the Adjusting the picture section in this
guide for more information.
5 .
6 .
Fujitsu 8/16/92 5:16 PM Page 10
To Next Page
Loading...
