1-6-5 H9300DC
Eject Hole
DVD Mecha
Deck Assembly
Paper clip (Available Locally)
Length = approximately 50mm
Straightened
portion = approximately 35mm
Tray
Top Cover
1
3
4
2
(S-13)
(S-12)
(W-1)
(W-1)
(W-1)
(S-14)
[16] Side Bracket
[14] Deck Pedestal-1
[17] Insulator
[13] Power Supply CBA
[15] Deck Pedestal-2
(S-11)
(S-11)
Bracket
(L-3)
Fig. D9
HOW TO MANUAL EJECT
1. Remove the Top Case.
2. Make a tool from a paper clip, etc., (length = approxi-
mately 50 mm, maximum diameter = approximately 3
mm) as shown below.
3. Insert the tool into the manual eject hole on the DVD
Mecha. Then, push it until the tray is ejected.
To Next Page
Loading...
