Need help?Do you have a question about the Furman ACD-100 and is the answer not in the manual?
General| Input Voltage | 120V AC |
|---|---|
| Output Voltage | 120V AC |
| Maximum Load | 15A |
| Number of Outlets | 8 |
| Surge Protection | Yes |
| Circuit Breaker | Yes |
| EMI/RFI Filtering | Yes |
| Input Frequency | 50/60 Hz |
| Output Frequency | 50/60 Hz |
Guides power source selection based on North American voltage (120V, 240V, 208V).
Details cable selection based on voltage, length, and portability.
Instructions for preparing and connecting the supply cable to the ACD 100 bus bars.
Guidance on splitting and balancing five 20 amp loads across available hot wires.
Steps for tightening the strain relief clamp and closing the unit after wiring.
Details on terminating the cable's source end, often as pigtails or with connectors.
Specifies input current, input voltage options, and output circuit details.
Details pulse tolerance and overload vs. trip time for circuit breakers.
Lists protection mode, clamping voltage, response time, and surge capacity.
Covers mechanical, construction, power consumption, and safety information.
To Next Page
