EasyManuals Logo

Furrion FACC10SA-BL User Manual

Furrion FACC10SA-BL
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
This quick start guide will help you install and use the device properly.
For further support please visit www.furrion.com/support.
WHAT’S IN THE BOX
Wa rra nty Man ual
Wa rni ng C ard
Qu ick St art Gu ide
Wa rra nty Ma nual
Wa rni ng C ard
Qu ick Sta rt Gui de
Control Box x 1
QSG x 1
Warranty Manual x 1
NOTE: Product design and packaging may change without notice.
INSTALLATION
WARNING
Risk of Electric Shock
Always verify that the electrical power to the circuit has been
disconnected before performing the installation procedures.
Wire Connection
Familiarize yourself with the controller and wire harnesses.
Wall Thermostat Cable
(4-wire harness)
Furnace Cable (2-wire)
12V DC Power Cable (2-wire)
Freeze Sensor Cable (wire with
copper tip and blue plastic clip)
1. Loosen the cable clamp on top of the control box and remove the
compartment cover. Pass the 115VAC power cord through the cable
clamp hole and make wire connections following the below color
codes:
Black - Hot
White - Neutral
Green/yellow - Ground
2. Fit all cables into the cable
compartment and tuck any excess
wires up out of the way. Re-tighten
the cable clamp, do not over tighten.
Replace the cover.
Cable Clamp
SINGLE ZONE CONTROLLER
MODEL: FACC10SA-BL
FACC10ESSA-BL
QUICK START GUIDE

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Furrion FACC10SA-BL and is the answer not in the manual?

Furrion FACC10SA-BL Specifications

General IconGeneral
ModelFACC10SA-BL
Input Voltage12V DC
Operating Temperature32°F to 122°F (0°C to 50°C)
ColorBlack
MaterialPlastic
CompatibilityFurrion appliances
FeaturesDigital display, touch controls
Weight0.18 lbs (0.08 kg)

Related product manuals