Furrion NET-ZERO FSCC30PW-BL

Questions and Answers

K
Kristina SaundersAug 7, 2025
What to do if the Fault LED is red on my Furrion NET-ZERO FSCC30PW-BL?
- K
  Katelyn NunezAug 7, 2025
  If the Fault LED on your Furrion Controller is red, it could be due to several reasons: * The battery polarity might be reversed. Check the battery connection and correct it if necessary. * The PV input might be reversed. Inspect the PV input connection and correct it if needed. * The battery might be overcharged. In this case, check the condition of the battery and replace it if necessary.
J
johnny46Aug 16, 2025
Why is my Furrion NET-ZERO FSCC30PW-BL battery not fully charged?
- M
  Mike MorenoAug 16, 2025
  If your Furrion Controller battery is not fully charged, there are several potential causes: 1. Too much load is connected to the battery. Try removing some of the loads. 2. The battery temperature is too low. Use the battery temperature sensor. 3. The battery type setting is incorrect. Choose the correct battery type by long pressing the button. 4. The battery wire is too small. Use a larger gauge wire for the battery to reduce voltage drops.
A
anthony92Aug 27, 2025
What to do if Furrion NET-ZERO FSCC30PW-BL battery is not charged?
- M
  Misty MccallAug 27, 2025
  If the battery is not charging on your Furrion Controller, consider the following: * Too much load might be connected to the battery. Try removing some loads to see if that helps. * The battery might be damaged. Check the condition of the battery and replace it if necessary.

Summary

Welcome

Important Safety Instructions

General Safety Precautions

Read all instructions before installation and follow warnings.

Charge Controller Safety

Never connect solar panel without battery; ensure input voltage limits.

Battery Safety

Use appropriate battery types and handle with care due to gases.

About Your Product

General Information

Details on MPPT technology, three-stage control, and protections.

Key Features

Highlights include MPPT efficiency, compatibility, and protective features.

Product Overview

Optional Components

Lists optional accessories like temperature sensors and mounting brackets.

Maximum Power Point Tracking (MPPT)

Charging Stages

Bulk Stage

Delivers maximum current to recharge batteries rapidly.

Absorption Stage

Constant voltage charging until current drops, then switches to float.

Float Stage

Maintains battery charge at a fully charged state.

Installation

Whats in the Box

Lists all items included in the packaging for the solar charge controller.

Solar Charger Mounting Bracket Installation

Refers to a separate manual for mounting bracket installation.

MPPT Solar Charger Controller Installation

Step-by-step guide for physically installing the controller unit.

PV Array Requirements

Specifies maximum PV power, voltage, and current limits for the controller.

Wire Size

Details recommended PV and battery wire gauge and length.

Operation

Operation Indicators and Controls

Details LED indicators for battery modes and charge status, plus button functions.

Protection

Protection Mechanisms

Covers over current, short circuit, reverse polarity, over voltage, and overheating protections.

Care and Maintenance

Maintenance Schedule and Tasks

Tasks include checking installation, cleaning, wire connections, and ground connections.

Specifications

Troubleshooting

Warranty

Furrion NET-ZERO FSCC30PW-BL Specifications

General

Model Number	FSCC30PW-BL
Category	Controller
Type	Solar Charge Controller
System Voltage	12V/24V Auto
Max. PV Input Voltage	100V
Max. Charging Current	30A
Battery Type	Sealed, Gel, Flooded, Lithium
Communication	Bluetooth
Weight	2.2 lbs
Protection Features	Overcharge, Over-discharge, Overload, Short Circuit
Max. PV Input Power	390W (12V) / 780W (24V)