What to do if my Furuno Sonar picture contains noise?
If your Furuno Sonar picture contains noise, check the equipment ground to ensure it is properly grounded. Also, relocate the power cable or signal cable if they are too close to each other. If there is debris on the sea surface, use the interference rejector on the COMN menu to reject unwanted noise.
Why is the echo weak on my Furuno Sonar?
If you're experiencing a weak echo on your Furuno Sonar, first check if the output power is set to minimum and set it to maximum on the COMN menu. Also, readjust TVG on the appropriate menu (HORZ, VERT, ES). Note that readjustment of TVG is necessary when gain is adjusted.
How to troubleshoot power issues on a Furuno CH-250 Sonar?
If your Furuno Sonar cannot turn on, check the cable between the transceiver unit and the display unit. Then, check the ship’s mains. Finally, have a suitably qualified technician check the fuse in the transceiver unit.
Why does the bottom echo become irregular on my Furuno CH-250?
An irregular bottom echo on your Furuno Sonar can occur due to rough seas, where the distance to the bottom changes because of rolling and pitching. It can also happen if a long range is selected, as the transmission period is longer, making the detection of echo susceptible to the ship’s pitching and rolling.
How to fix a Furuno CH-250 Sonar that cannot turn on?
If the Furuno Sonar will not turn on, check the cable between the transceiver unit and display unit. Also, check the ship’s mains. If these do not solve the problem, have a suitably qualified technician check the fuse in the transceiver unit.
Why does my Furuno Sonar have a strange color?
If you see a somewhat strange color on your Furuno Sonar, increase brightness with the [BRILL] key, because the [BRILL] key setting may be too low.
Why does the Furuno CH-250 bottom echo become irregular?
An irregular bottom echo on your Furuno Sonar can occur due to rough seas, where the distance to the bottom changes due to rolling and pitching. It can also happen when a long range is selected, as the transmission period is longer, so the ship’s pitching and rolling are apt to affect detection of echo.
Read manual, follow descriptions, save for reference, and avoid unauthorized modifications.
Warnings regarding electrical hazards, water leaks, disassembly, smoke, fire, and keeping heaters away.
Details the functions of each control on the main unit.
Step-by-step guide for turning the sonar system on and off safely.
Procedures and cautions for operating the transducer's vertical movement.
Guidance on setting the gain control for optimal echo display.
Sequence of operations for using the horizontal mode.
Explanation of the various indicators and data shown on the horizontal display.
How to select the appropriate range setting for sonar operation.
Guidance on setting the tilt angle for effective fish detection and bottom analysis.
Techniques for suppressing reflections and displaying weak echoes clearly.
Explanation of manual reverse, position, and echo target lock modes.
How the horizontal display picture is painted and sample echo displays.
Sequence of operations for using the vertical fan mode.
Explanation of the indicators and data shown on the vertical fan display.
How to select the appropriate range setting for vertical fan mode.
Techniques for displaying weak echoes and suppressing noise in vertical mode.
Displaying weak echoes and adjusting TVG settings in echo sounder mode.
Table of common symptoms and remedies for equipment problems.
List of potential error messages and their meanings or remedies.
How to run diagnostic tests and interpret the results.
Details on display system, transmit frequency, output power, and factory range settings.
To Next Page
General
