2. INITIAL SETUP
10
Initial setup
Refer to the information described in this manual and the manual of the display unit
(FR-10/12, TZTL12F/TZTL15F/TZT2BB, TZT9F/12F/16F/19F) to do the initial setup.
1. Power the radar sensor and the display unit. Warm up of the magnetron begins.
2. If communication between the display unit and this unit is established, a count-
down or "preparation" appears on the display. If not displayed, check that the ra-
dar sensor is connected to the display unit and that the settings on the display unit
are correct (see the operator’s manual for the display unit).
3. Transmit and confirm that radar echoes appear on the display.
• If the FR-10/12 is connected as a display unit, set the following items. For other
display units, confirm and set the antenna rotation speed, align the heading,
suppress the main bang, set sector blanking area(s), set the tuning mode, and
tune the radar manually. See the display unit’s installation manual for the pro-
cedure.
([Installation Setup] menu)
Note: The items on the [Installation Setup] menu come into effect after completing
the following settings.
1) Press the [MENU] key to open the menu.
2) While pressing and holding down the [ESC/HL OFF] key, press the [MENU]
key five times.
([Sector Blanking] menu)
([Tuning/TX Channel] menu)
Menu item Description
[Antenna Rotation] Set the antenna rotation speed (Settings: Auto, 24 rpm).
[Antenna Heading Align] See “How to align the antenna heading.”
• Make sure the heading line is displayed in the correct
direction. Check that targets are displayed in the cor-
rect direction with respect to the bow.
[Sweep Timing] Adjust the sweep timing (Setting range: -10 to 10).
[Main Bang Suppression] If main bang appears at the screen center, slide the cir-
cle icon, while watching the radar echo on the left-side
of the display, until the main bang disappears.
Menu item Description
[Enable Sector Blanking 1],
[Enable Sector Blanking 2]
Up to two sectors may be set for blanking (no transmis-
sion). Select [ON] to enable this feature. Set the start
and end angles (0° to 359°).
Menu item Description
[Tuning Mode] Set the tuning mode, automatic or manual, for the con-
nected radar
[Manual Tuning] Manually tune the radar. Not available when [Tuning
Mode] is [Auto].
[Tuning Initialization] If the radar cannot be tuned, initialize tuning.
To Next Page
Loading...