Furuno FAR-2107 Series - Page 5

3
1) Set cushioning material on the console table and then place the monitor unit on the material, LCD side
down. Connect the power cable (attached to the console), ground wire (attached to the console) and
cable assembly (DVI-D/D S-LINK 5M, attached to the console) to the monitor unit.
2) Attach the panel hooks (accessories for the monitor unit) to the location shown in the exploded view
below. Fasten the monitor unit to the console with four screws (M6×25).
3) Attach the cosmetic caps (accessories for the monitor unit) at four locations.
Cable Assembly
(DVI-D/D S-LINK 5M)
View
A
For MU-231CR
Power Cable
Ground Wire
Cable Clamp
Screw
Screw
(M4, 2 pcs.)
Connector Cover
Screw
(M4, 2 pcs.)
Pinch shield
and fasten it
with
two screws.
Hook
A
Pinch
between
plain
washers.
Approx. 45°
For MU-201CR
Screw Attached
to Terminal Board
Conductor Side
Conductor Side
Approx. 45°
View
Screw
(M6x25, 4 pcs.)
Monitor Unit
Panel Hook
Cosmetic Cap
Screw for Fixing
Monitor Unit
EXPLODED VIEW
Fixing Hole
Fasten monitor unit to console.