6
6 If the Video LAN converter IF-7100 is installed, do steps 6 to 7. Fasten the AC-DC Power
Supply unit PR-240 (option) to the console with the optional VLC installation kit OP03-233.
NOTE: If the DC power line is connected to IF-7100, the PR-240 is not required.
1) Fasten the PR-240 to the PR fixing plate (03-163-7276-0) with four upset hex. bolts (M5×12).
For FAR-2137S/2837S
The Power Supply Unit PSU-007 also is fastened to the PR fixing plate.
Remove the four screws (M4) then detach the cover of PSU-007. Fasten the PSU-007 to the PR fixing
plate with the upset UI hex. bolts (M5×12). Fasten the cover detached with the original screws.
2) Fasten the PR fixing plate assy. to the console with four upset bolts, referring to the figure below. Attach
the PR-240 so that the terminal block is upward.
3) Attach the Fixing beam assy. (OP03-233-1) to the console.
4) Attach the clamps as below.
PR-240
Terminal block
PR fixing plate
PR fixing plate assy.
PSU-007
Screw (M4, 4 pcs.)
+Upset bolt
(M5×12, 2 pcs.)
+Upset UI bolt
(M6×12, 2 pcs.)
Beam assy., M6×12, 2 pcs.
Beam assy., M6×12, 2 pcs.
VLC assembly
PR-240PR-240
Rear left ductRear left duct
PR-240PR-240
Rear right ductRear right duct
Clamps
: CKS-20-H
: CKS-13-H
To Next Page
Loading...
