3. ADJUSTMENTS
3-26
[SHUTTLE FERRY SWITCH]
Note: This menu is NOT available for C-type radars.
Select a port to detect a navigation direction of a shuttle ferry (default: [RS-232C]).
[ECDIS ROUTE DISPLAY]
Note: This menu is NOT available for C-type radars.
Select [NORMAL] to show the routes with a straight lines, [LEGACY] to show the
routes with a curve lines.
3.6 How to Control Charts
This section shows you how to install or update charts for C-type and A/B/W radars
with Radar Plotter functionality.
3.6.1 How to install charts
Note: Save the chart data to a USB flash memory first. You do not need to create a
folder.
1. Connect the USB flash memory with chart data to the USB drive from the RP
board.
2. Press the MENU key to open the main menu.
3. Select [INITIAL SETTINGS].
4. Select [UPDATE CHART]. The following message appears.
5. Select [RUN]. The message "PROCESS-
ING. PLEASE WAIT." appears, then the
[CHART ADMINISTRATION] menu ap-
pears.
6. Select [COPY CHART FROM USB DEVICE] to display the list for data in the USB
flash memory.
7. Select the chart data to copy.
[NORMAL]
䠄
Straight line
䠅
[LEGACY]
䠄
Curve line
䠅
OTHER FUNCTIONS WILL STOP DURING
THE CHART UPDATE.
ARE YOU SURE?
㻾㼁㻺䚷䚷䚷㻌㻌㻌㻌㻌㻯㻭㻺㻯㻱㻸
CHART ADMINISTRATION
1. DISPLAY CHART LIST
2. COPY CHART FROM USB DEVICE
3. LOAD CHART UNLOCK CODE
4. INTERNAL MEMORY MANAGEMENT
5. REMOVE USB DEVICE
6. BASECHARTS ∙ SYMBOLS VERSION
7. CLOSE
To Next Page
Loading...
