1. INSTALLATION
1-19
1.4 Control Unit
The Control Units can be installed on a desktop or flush mounted in a console.
Installation considerations
Keep in mind the following points when selecting a location.
• Select a location where the Control Unit can be operated easily.
• Locate the unit away from heat sources because of heat that can build up inside the
cabinet.
• Locate the equipment away from places subject to water splash and rain.
• Leave sufficient space at the sides and rear of the unit to facilitate maintenance.
• Determine the location considering the length of the signal cable between the Con-
trol Unit and the Processor Unit.
• A magnetic compass will be affected if the Control Unit is placed too close to the
magnetic compass. Observe the compass safe distances in the SAFETY IN-
STRUCTIONS to prevent interference to the compass.
1.4.1 Desktop installation
For desktop installation, the unit can be laid flat or tilted.
How to mount the unit tilted
<RCU-014/015/016>
1. Fit the KB fixing plate (in FP03-09850 for RCU-014, in FP03-09860 for RCU-015/
016) to the bottom of the Control Unit.
2. Attach the rubber foots (three for RCU-014, two for RCU-015/016) to the bottom
of the Control Unit as shown in the following figure.
3. Install the Control Unit at the de-
sired location with self-tapping
screws (local supply).
Bridge
window
Viewing pointViewing point
Viewing pointViewing point
Bridge window
KB fixing plate
Rubber Foot
To Next Page
Loading...
