1. INSTALLATION
1-7
3. Coat the grayed area shown below with the supplied adhesive.
4. Grease the O-ring and set it to the O-ring groove of the radiator flange.
5. Set the supplied spring washers and flat washers then coat the adhesive to the
threads of the supplied hex. bolts M840.
6. Set the antenna radiator to the radiator bracket.
7. Remove the two guide pins (insert-
ed at step 1), and then tighten fixing
bolts. The torque must be 15 N•m.
8. Coat hex bolts M840 with the supplied adhesive and
use them to loosely fasten the antenna radiator to the
Antenna Unit chassis.
Radiator bracket
O-ringO-ring
Gray: Adhesive
10 mm10 mm
5 mm5 mm
O-ring
Radiator bracket
Waveguide
Antenna radiator
Hex bolt
(M8×40,
w/plain washer and
spring washer),
8 pcs.
Guide pin
Be sure to remove the guide pins.
Injury may result if the guide pins loosen
and fall.
CAUTION
To Next Page
Loading...
